|
Self-Locking Rings |
 |
SHF - Self-Locking Ring
External Friction Inch Ring - This ring resembles a regular SH ring except that it is designed to function on a shaft without a groove. The design of the ring causes it to exert significant gripping power uniformly on the shaft (except where the gap occurs). Size Range: .059-.750 Inches.
SHF.pdf |
 |
TX/TY - Self-Locking Ring
External Toothed Inch Ring - This ring features an outer rim with a series of prongs protruding into the center. The ends create interference with the shaft when the ring is installed and a load introduced to the other side. The difference between these two rings is that the outer rim of the TX is curved while the rim of the TY is flat. Size Ranges: TX--.094-1.0 Inches; TY--.094-1.0 Inches; DTX—1.5mm-45.0mm.
TX.pdf
TY.pdf |
 |
TI - Self-Locking Ring
Internal Toothed Inch Ring - The internal version of the TY featuring a series of prongs protruding into the center. The ends create interference with the housing when the ring is installed and a load introduced to the other side. Size Ranges: TI--.312-.938 Inches; DTI—8.0mm-50.0mm.
TI.pdf |
 |
RG - Self-Locking Ring
Radial Grip Inch Ring - This radially installed ring makes its own groove on a soft shaft which significantly increases its holding power. It can also be installed directly against the face of the retained part, virtually eliminating end play. Automate installation using a Rotor Kick, Jr. Pneumatic installation tool. (Note: this product works only on "soft" shafts). Size Range: .092-.379 Inches.
RG.pdf |
